Take a look at our 3d printing and laser cutting training here! Click here!

MiFare Classic (13.56MHz RFID/NFC) Clear Tag

SKU: ZO-747
Model/MPN:
Availability: 8
10.75AED
Qty: Add to Cart

MiFare Classic (13.56MHz RFID/NFC) Clear Tag

This is a blank MiFare Classic 'laundry' tag - often used for laundry or identification but also found in other systems where a small proximity card is desired. This one is clear! The tag contains a NXP S50 chip and an antenna, and is passively powered by the reader/writer when placed a couple inches away.

These can be read by almost any 13.56MHz RFID/NFC reader but make sure it can handle MiFare cards as there are a few other encoding standards (like FeLica) They are tested and work great with both our PN532 NFC/RFID breakout board and Adafruit NFC/RFID Shield for Arduino!

These chips can be written to & store up to 1 KB of data in writable EEPROM divided into banks, and can handle over 100,000 re-writes. You can use our PN532 NFC/RFID breakout board or Adafruit NFC/RFID Shield for Arduino to read and write data to the EEPROM inside the tag. There is also a permanent 4-byte ID burned into the chip that you can use to identify one tag from another - the ID number cannot be changed.
 
Technical Details

S50 chip specification:

  • 1 KiloByte (8 KiloBit) non-volatile EEPROM storage
  • Built in encryption engine with 48-bit key
  • 4 Byte unique identifier burned into the chip
  • 13.56 MHz frequency
  • Tag specification:

  • 25.4mm diameter x 1mm / 1" diameter x 0.03"
  • 0.9 grams / 0.03 oz
  • Works about 2" away from reader
There are no reviews for this product.

Write a review

Your Name:


Your Review:Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: