The cable is easiest way ever to connect to your microcontroller/Raspberry Pi/WiFi router serial console port.
Inside the big USB plug is a USBSerial conversion chip and at the end of the 36" cable are four wire - red power, black ground, white RX into USB port, and green TX out of the USB port.
Because of the separated pin plugs, this cable is ideal for powering and connecting up to the debug/login console on the Raspberry Pi or BeagleBone Black.
Connect the pins as shown to power the Pi or BBB and establish the RX/TX link.
Then install the Windows XP/Vista/7 or MacOS X PL2303HX drivers on your computer and connect with a terminal program at 115200 baud.
Windows 8 is now supported! If you're using Windows 7 and you have issues, try theProlific driver version 1.013.
This is easier to use than an FTDI cable in many cases because the wires are separated This cable is not good for Arduino re-programming such as a Boarduino, MENTA, Monochron, etc.
There are four wires: red power, black ground, white RX into USB port, and green TX out of the USB port.
The power pin provides the 5V @ 500mA direct from the USB port and the RX/TX pins are 3.3V level for interfacing with the most common 3.3V logic level chipsets.