Get your VAT back + 15% discount on all items. (Coupon code: VAT+15%OFF)

PIR Motion Sensor (JST)

SKU: ZO-1124
Model/MPN: SE-10
Availability: 13
41.90AED Ex Tax: 39.90AED
Qty: Add to Cart

PIR Motion Sensor (JST)

Do you need a motion sensor? It’s very helpful. In fact, it’s simple to use since all you need to do is to power it and wait for a few seconds, and *BAAM* a snapshot of the room has been taken, and then the creepy part starts; whenever anything moves after that snapshot, the alarm pin goes low!

This unit works great from 5 to 12V! Also, installing a jumper wire past the 5V regulator on board is possible in order to make this unit work at 3.3V. Sensor uses 1.6mA@3.3V.

The alarm pin is an open collector which means that a pull up resistor is needed and is very crucial to have on the alarm pin. The open drain setup allows multiple motion sensors to be connected on a single input pin. Check the following important meanings.
Red = Power, White = Ground, and Black = Alarm.



3cm x 3.5cm x 2cm
20cm (wire)
There are no reviews for this product.

Write a review

Your Name:

Your Review:Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: